![]() The tester’s computer system is very user friendly to where programs for 20 different types of scaffold planks can be accessed immediately. How is the tester programmed for different lengths plank and different loads ? Most customers prefer the automatic hot branding. ![]() As a feature Indian Mill also provides a hot branding device to automatically burn in the date that the plank passed the test. How is a plank marked to show date of test ?Ī customer can mark his own planks with testing stamps or paint the end of the plank with the color of the month to signify testing. Testing information is very important for inventory control and plank tracking. The test data is stored in the onboard computer and can be down loaded to a central system as the test are being run or in daily reports. ![]() Also at some point in time every plank will have to be removed from service and only by testing can you know when that time is.Ĭan all scaffold planks be tested on this machine ?Īll planks up to 12 inches wide and 20 feet in length can be tested.Ĭan the plank test info be sent to a central control center ? When manufacturing a new scaffold plank the process of qualifying a piece of wood to be a scaffold plank is extensive but with time and use that same plank can be physically damaged to where it no longer can safely support a worker. The answer is: No one knows with out periodic inspection and testing. How long can a scaffold plank be safely used ? Recalibration of tester electronics is to be done annually. The calibration of applied weight is to the one tenth of a pound.Ĭalibration of length of deflection is to the one tenth of an inch. What are the Accuracy and calibration procedures of SPT6 ? Non-Destructive testing is no more damaging than a worker walking across a plank. The measured deflection stayed with in 1/100 of an inch for the complete test. In house testing has run 1,000 iterations on the same test piece without any damage. The testing of the plank will in no way damage the wood fibers in a qualified scaffold plank. ![]() Used planks need to be visually checked for rot, acids, alkali, burns, cuts and any other physical damage that obviously require throwing it out but after the visual inspection has been done the plank can be verified as meeting all OSHA and ANSI standards of strength and deflection using the Scaffold Plank Tester from Indian Mill. Visual inspection and machine testing is the only way to know if the planks can safely support the worker and equipment. There are many things on a scaffold job that can damage scaffold plank. Scaffold planks get beat, banged, ran over, sawn, drilled, welded on water soaked, dried out, and in Industrial plants gets exposed to chemicals and acids. The center piece of the program is the Indian Mill SPT6 Scaffold Plank Tester. What value is a scaffold plank testing program ?Ī scaffold company with a plank testing program can virtually eliminate plank accidents. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |